There are times I get asked what camera equipment, what software, and what tools I use. I thought this might be a way to refer anyone who ask and give you a better idea of what kind of equipment I like to use. Of coarse I have some updates to do and other tools. The list below is a good start to my collection and will continue to add to this list and refer anyone who ask about what I use to this list. All the link are added and some tools has been updated sense I’ve purchased them. I provided the updated tool link, but have no experience with the newer version.
Last Time Updated
Continue reading “Equipment”
Quick Disconnect System for your tools
I know, i cant be the only one that gets tired of wrapping up the cords to the tools every time its in the way or when your ready to clean up for the day. I think i have came up with a quick disconnect system to install on yours tools. I use a combination of IEC connectors and came up with a “festool like” system for cord management.
Continue reading “Quick Disconnect System”
Whats the rage all about?
I have been given a chance to test out and play with the Rage3 10″ sliding miter saw. Evolution is working hard to get establish in the US and has asked me to check out and review the Rage3 saw. I have created a video for your viewing and here are some after thoughts to follow up with the video.
Continue reading “Whats the rage all about?”
Drill Bit Storage Cabinet
I needed to get all my drill bits in one place. This cabinet is going to fit under the drill press and store all the drill bit in my shop. Including the Kiss Drill Bit System from FastCap. This can also be used for a bench top drill press stand. Add some wheels maybe go a bit higher with the cabinet this could be a good solution for those bench top drill presses.
Continue reading “Drill Bit Storage Cabinet”
Hickory box with Gorilla glue finish
I set out to accomplish two things with this build. One I wanted to try this new finish method I learned from “Ask This Old House” The showed a method of using Gorilla Glue for a finish and it turn out awesome. It looked easy enough so I wanted to do it. Second, I never build a box using grain matching techniques before. I wanted the grain to wrap around the box, also book match the lid panel. That was the whole plan behind this build.
Continue reading “Hickory Box”
A while back I started a dividing wall in the shop. This dividing wall had many different ideas for. I was working on plans for a panel saw at one point and a panel clamping system at another point. I have decided to put my woodworking clamps up instead. Here’s how I did it. I have plans available for this clamp rack in my shop.
Continue reading “Clamp Rack”
Now that the miter station is pretty much done. I have room and a need for an assembly table. This is one of those projects that has been way over due. I have use the out feed table as an assembly table for years. This works, but you end up having to move a lot of stuff to make the next cut. A dedicated assembly table is the answer. Plans are available for this build.
Continue reading “Assembly Table W/Plans”